In our example, the command does the following: Where the info is replaced by whatever you want to use. So, for example, your command might look something like the following: netsh interface ipv4 set address name="Wi-Fi" static 192.168.3.8 255.255.255.0 192.168.3.1 To do this, you’ll issue a command using the following syntax: netsh interface ipv4 set address name="YOUR INTERFACE NAME" static IP_ADDRESS SUBNET_MASK GATEWAY With the interface name in hand, you’re ready to change the IP Address, subnet mask, and gateway. Change Your IP Address, Subnet Mask, and Default Gateway You can also copy and paste the name to Notepad and then back into Command Prompt later to make things easier. In our example, we’re going to modify the Wi-Fi interface, which on our machine is just named “Wi-Fi.” You’ll also see other default names that Windows assigns to interfaces, such as “Local Area Connection,” “Local Area Connection* 2,” and “Ethernet.” Just find the one you’re looking for and make note of the exact name. Scroll down until you see the interface you’re looking for. IP ADDRESS MAC TERMINAL COMMAND HOW TORELATED: How to Enable CTRL+C / Ctrl+V for Pasting in the Windows Command Prompt To do this, type the following command: netsh interface ipv4 show config IP ADDRESS MAC TERMINAL COMMAND FULLRELATED: How to Find Your Private and Public IP Addresses View Your Network Informationīefore you change your IP address and related information, you’ll need to find the full name of the network for the interface you want to change. IP ADDRESS MAC TERMINAL COMMAND WINDOWS 10In Windows 10 or 8.1, right-click the Start menu (or press Windows+X on your keyboard) and choose “Command Prompt (Admin).” In previous versions of Windows, search Start for “command prompt” and then right-click the result and choose “Run as Administrator.” To work with it, you’ll need to open Command Prompt with administrative privileges. However, I'm thinking by now you already figured this out.The netsh command allows you to configure just about any aspect of your network connections in Windows. In summary, you'll want to be careful and key off indicators such as in ifconfig noting: status: no carrier vs active and for those with IP assignment on the individual interface, you can match via the inet address. I have exhibited the following alignment where ext-1 = em2 (from the list of em0, em1, em2, and em3) For instance ( color coding used to emphasize what one *may* expect):Įven the InfiniBand ports don't align as you *may* expect:ġ) When you have the 2 on-board (Cu) 1gig interfaces, the numbering while it doesn't match, is at least aligning in ascending order: ( em0 = ext-1 and em1 = ext-2)Ģ) However, notice the 10gig interfaces where while cxgb1 = 10gige-1 (number reference matches), *but* then cxgb0 = 10gige-2 which doesn't match the ascending order.ģ) This changes when you have 4x (Cu) 1gig interfaces (2x onboard + 2x expansion). Simply wanted to point out that mapping the (individual) interface names at the OS level (via ifconfig) to the naming used by OneFS could be a bit confusing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |